Sunday, August 7, 2011

Liberty Pumps S37 1/3-Horse Power 1-1/2-Inch Discharge S30-Series Builders Series Submersible Sump Pump with Vertical Float





Liberty Pumps S37 1/3-Horse Power 1-1/2-Inch Discharge S30-Series Builders Series Submersible Sump Pump with Vertical Float Overview

Liberty Pump S37 is 1/3HP Automatic Submersible Sump Pump with an integrated vertical float switch and 10ft power cord. This Liberty Pump has 1-1/2" NPT discharge and 1/4" solids-handling with higher intake screening that helps reduce debris from entering the pump compared to bottom suction designs.Turn-on level of the switch is 8.25" and turn-off level is 2.75". The turn off position can be adjusted by sliding a rubber grommet up or down the length of the float rod.For automatic operation with the included switch, the two cords should be interconnected and plugged into a separately fused, grounded outlet of proper amp capacity for the pump. Both cords are equipped with 3-prong plugs and must be properly plugged into a properly grounded 3-wire receptacle. DO NOT REMOVE THE GROUND PRONGS.For manual operation, or in the event of switch failure, the pump cord can be separated and plugged directly into the electrical outlet, bypassing the switch. The unit can be operated by directly plugging the pump cord (from the motor) into an approved electrical outlet. To prevent excessive seal wear and overheating, the pump should not be run dry for extended periods of time. A minimum 2-1/2" water level is recommended.

Available Stores

PexUniverse
$99.95 (New)
Usually ships in 1-2 business days
Amazon.com
$116.06 (New)
Temporarily out of stock. Order now and we'll deliver when available. We'll e-mail you with an estimated delivery date as soon as we have more information. Your credit card will not be charged until we ship the item.

No comments:

Post a Comment